Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> How to Properly Read a Compression Test Gauge?
User Name
Password
lost password?   |   register now

Thread: How to Properly Read a Compression Test Gauge? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-22-2012 06:54 AM
cdminter59
How to Properly Read a Compression Test Gauge?

Testing a salvage yard motor is not that hard. Have a squirt can of oil with you. Pull all the plugs. Remove anything else that will make it easier to turn the motor over with a socket and breaker bar. Check each cylinder writing down the reading of each. The readings should be within 10% of each other, If you have a low one try and squirt oil in that cylinder and take it again to see if it goes up. If not there is an internal problem. Ask if you can remove the oil pan and remove some main and rod caps to see how much bearing wear. Turning an engine over by hand I doubt you will have any high readings. Usually some yards have a way to set an engine up on a stand and run it for testing. This would be nice. You could see how much total vacuum the engine pulls. An used engine that pulled close to 15 LBS would be good.
08-22-2012 05:54 AM
454C10 The numbers should all be about the same.

Stock BBC's are typically low compression so don't expect high numbers. 125 psi is about it.

flat cam lobes and worn out bearings will be the biggest issue, and that will be hard to see at a salvage yard.
08-22-2012 01:01 AM
Mrboykin0
How to Properly Read a Compression Test Gauge?

Pulling an engine out of an salvage yard
(Big Block Chevy)

I understand how to do the test.
assuming the engine is warm/hot

But What are numbers i should look out for?

What is considered red flag and what is not?
What is are good numbers?

and if the cylinder(s) has low numbers does that mean the piston is bad? is the engine worth pulling?
can the compression be TOO HIGH?

Please help me?
- Hardcore Novice

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:28 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.