|08-29-2012 04:09 PM|
I put a Posie's offset steering gearbox in a '32 Ford last year.
After the fact, I was told that the car will never pass the NSRA safety 23 again because of the steering shaft offset box.
Are there any NSRA inspectors out there who can confirm or disprove that?
|08-29-2012 12:06 PM|
|da34guy||Posies has 1 also, gear drive (No Chain)|
|08-28-2012 07:20 PM|
|cal1320||Speedway sells them.|
|08-27-2012 11:37 PM|
A thread- Technical Chain/Gear Drive Steering Ideas/Comments? - THE H.A.M.B.
The enclosed one below is from "Steer Clear" (bring your wallet!):
|08-27-2012 11:22 PM|
nifty steering relocator
I visited a hot rod shop last saturday and observed a new part on many of the rods they were building. it is polished aluminum, approx. 14" high, 4 " wide and 1" deep.it as mounted near the firewall inside the cab, it allowed the steering column to be mounted almost parallel to the floor and had a chain drive enclosed set of gears. the shaft going out the firewall to the rack was well out of the way of headers, down near the frame rail. what are these called and where can you get them?