|09-25-2012 04:05 PM|
I tried that on the other side with the epoxy primer, but I must have rushed the second coat as the Bondo showed through. I got a few runs where I tried to paint the inside of the pockets. Good thing I am working with the primer I can repair the primer. Iíll probably have plenty of coats of primer before the AE.
Iím hoping for better results with poly and AE.
|09-22-2012 08:00 PM|
Thats what I do narrow it down to almost a circle spray then widen the fan out a little make another run then widen the fan again and finish,That way it keeps a wet edge, Adjusting my paint flow as I go.
|09-13-2012 07:23 PM|
|monster76||how did it turn out? any pics of it|
|08-28-2012 08:26 PM|
|monster76||post some pics of the results hope it works out for you.|
|08-28-2012 08:20 PM|
I have the sides off the truck and the fenders are also off.
I will try the narrowing of the fan on the other side. Wish me luck.
|08-28-2012 06:00 PM|
|monster76||i don't know if its the right way but it has worked for me if you can pull the fenders off assuming its bc/cc make your fan narrow and do several light coats up in there with a little more distance than usual and then widen the fan and continue painting as normal it has worked for me but then again i did only once and i guess it was more luck than skill|
|08-28-2012 05:29 PM|
Stepside bed painting
I would think that if you took the fenders off, you could probably paint the area you are speaking of. You may need to use a "detail" (aka jamb gun) to do it, but I think just removing the fenders will help you immensely.
Dennis W. Parks
author of automotive how-to books
|08-28-2012 04:34 PM|
Painting a step side
How do I paint up under the roll at the top of a step side pickup bed?
I have a gravity feed gun and a siphon feed gun, but I canít seem to get the right angle to hit up under the rolled edge.
I tried to turn the bedside upside down to apply epoxy primer but that didnít help I just got a lot of runs trying to get the correct angle.
Do I need a special gun or tip with a 90 degree angle?