Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> What chevy 10 bolt axles have 3" dia. tubes?
User Name
Password
lost password?   |   register now

Thread: What chevy 10 bolt axles have 3" dia. tubes? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-03-2012 08:50 PM
GARY HOOTEN First I want to thank you very much for your wealth of information. I really appreciated it's thoroughness of subject. You cannot believe how much unsuccessful internet searching I have endured on this subject! And for that to stop.......... I thank you again.
It's to bad that old Dana 44 has 4.89 gears and 2+9/16 tubes. It sure would save me some cash..........
10-03-2012 07:25 PM
big gear head All of the 8.5 car rear ends have 3 inch tubes, along with the 8.2 rear ends. The first gen Camaro and '68 up Nova rear ends are 60 inches wide overall and the 2nd gen Camaro rear ends are 61 inches wide. The 60 inch rear ends are going to be around 55 inches between the backing plates, which is not a good way to measure rear ends. You need to measure the total width.

The Dana 44 is a very good rear end. Maybe you should put new bearings in it and use it.
10-03-2012 05:07 PM
GARY HOOTEN
What chevy 10 bolt axles have 3" dia. tubes?

I am in the process of installing a T.C.I. rear 4-link coil-over set -up in my 1955 F100 frame. Their axle brackets are designed for a 3" axle. I was originally going with a "85" S-10 axle which has a 2 5/8" diameter. Now I need a 3" dia. axle, at least 55" between the backing plates, centered third member and a ratio around 3.0 or 3.50 for high way driving.
I will be installing a SBC 350 and 700r4.
I just thought of another question: How good are the original 1955 F100 axles? Strength is probably good, but I wonder about 70 mph driving for long distances? It is a Dana 44.
So.......What chevy 10 bolt axle can I use?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:18 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.