Hot Rod Forum banner

Rearend set up.......?

852 views 3 replies 3 participants last post by  64 elky 
#1 ·
On an "A-body" application 4-link set up with tubular adjustable top and bottom bars. What would be my starting point for a drag application. -6degrees? Or only -4degrees? (Because I have only about 440hp. With a 28" tall tire with 4.10gear.)
 
#3 ·
Driveshaft angle

I also have a rear end question (as this is my first project like this and I have many questions). I, too, have a 4 bar adjustable rear end in my narrowed 9" Ford. From my transmission tail shaft, to my rear end, what is the permissable degree the driveshaft van be without any problems? This car is for street use only. Also, currently, I do not have my body on my chassis and was advised that it should be mounted before a driveshaft is made. That is, do not have the driveshaft made until all the weight is on the chassis. Help Please!!! By the way, here are some pictures of my setup.













 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top