Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Timing 86 305
User Name
Password
lost password?   |   register now

Thread: Timing 86 305 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-09-2012 01:27 PM
cdminter59
Timing 86 305

Sounds like you might be 1 or 2 teeth off. Pull the number 1 spark plug and get the piston at TDC. Pop the cap to see which plug wire the rotor is pointing at. It ain't the correct way but you can rewire the cap starting with #1 plug wire at the tower the rotor is pointing. If it is pointing to #6 spark plug wire pull the distributor and rotate it 180*.
10-08-2012 08:20 PM
greendragon13 I'm using a timing light. I don't know the exact position of the timing, but when the light flashes for #1 the mark on the balancer is roughly 10 degrees clockwise on the balancer or advanced. I can't even retard the timing enough to get it back to zero without it trying to die.
10-08-2012 08:15 PM
cdminter59
Timing 86 305

How are you setting the timing? Do you have a timing light pointed at the scale and it reading 10* ATDC? Then when you try to set it on 10* BTDC it runs bad. Did you remove the distributor after changing the timing chain set? Do your self a favor and start all over. Read this article it will help. http://www.crankshaftcoalition.com/w..._a_distributor
10-08-2012 05:48 PM
greendragon13 No. The timing tab is at 12 o'clock. When I replaced the timing set and had it lined up, I checked the balancer and it was at zero.
10-08-2012 10:18 AM
malc My 86 305 had the timing tab at twelve o clock over the harmonic balancer,
did you replace the timing cover with a tab at two ?
10-08-2012 09:55 AM
greendragon13 No. I rotated the crank 360 puttin it on one and put the distributor.
10-08-2012 09:50 AM
va4cqd crank dot at 12 and cam dot at 6 is #6 cylinder firing, not #1
10-07-2012 07:37 PM
greendragon13 Just one keyway.
10-07-2012 07:34 PM
adantessr Did your crank gear have multiple keyways ? If so, did you use the same mark on the sprocket as on the keyway ?
10-07-2012 07:28 PM
greendragon13 When I removed and replaced the timing set, the crank gear was at 12 and the cam gear was at six. I have the vacuum advance disconnected and plugged.
10-06-2012 09:13 PM
cdminter59
Timing 86 305

When you changed the timing gear set were the dots on the crankshaft at 12:00 position and camshaft at 6:00 position? Do you remember where they were aligned when you took the old timing chain off? When checking the timing is the vacuum hose disconnected from the distributor and plugged.
10-06-2012 07:07 PM
greendragon13
Timing 86 305

I have a 1979 K5 with a 1986 305. I changed the timing set because the original was badly worn. Edelbrock Performer EPS intake and 1406 carb. The engine runs great at idle, but when I go to time it the mark on the distributor is off to the side at around 10 degrees ATDC. I retard the timing to where it should be, 10 degrees BTDC, and the engine won't hardly run and it diesels really bad when I shut it off. There is also no power. The harmonic balancer is good because I checked it after I changed the timing set. Any help is greatly appreciated guys. Thanks.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.