|07-23-2015 05:57 PM|
I plan on painting an engine soon with Epoxy primer and House of Kolors Basecoat Kandy oriental blue.
Wondering how it'll hold up
|03-14-2014 11:54 PM|
Nice Your garage too !!!! Mine is flooded from the 4 foot snow & ice melting around it LOL !
I'll be up all night sweeping and pumping the water out
|03-14-2014 09:37 PM|
|327NUT||I screwed up...........here's the new home.|
|03-14-2014 09:28 PM|
|327NUT||The Cad was already .030 with only 30k on the orig rebuild, no ridge or taper so we just kissed the cyls. for a set of cast rings. It's going into this ....Eventually. All new parts except pistons, built it for today's crap gas so it's 8.7:1 comp. but it still dyno'd 466 hp and 535 torque at 4300 rpm. It's going to have this for a home.|
|03-12-2014 07:46 PM|
|03-12-2014 07:43 PM|
Thay looks great looks like the top of cyl have ben taper honed at top to make rings easier to install
What is tha big ole 500 Caddy going in,
shaft mounted roller rockers a nice touch making a stable valve train,
|03-12-2014 07:36 PM|
|327NUT||Old thread.........oh well, here's my Cadillac with the Glypta.l|
|03-12-2014 05:34 PM|
just a side not after cleaning the block as clean as possible I use a heat gun and a hand held propane torch to remove ALL signs of grease ,oil or FINGERPRINTS before painting POR 15 is a great choice there is not a chemical that I have found that will remove it, one of my recent builds
|03-12-2014 04:33 PM|
|05-24-2013 09:02 PM|
thread is old
|05-24-2013 08:51 PM|
makes sure you have the block thoroughly cleaned of all dirt grease and grime. its good to either pressure wash it down with a strong engine degreaser first. I like to use carb cleaner after I do that with a stiff brush, then I wipe it down several times with a good prep solvent and let it air dry.
Personally I just use the dupli -color straight out the can, light coats until I get a smooth consistent color coat. Whether you like to use clear on top of the color I believe is personal choice. I never use the clear unless its a trailer queen.
|03-03-2013 05:23 PM|
|fy54957||I uses Eastwood High-temp-ceramic engine paint (Quart)-$34.99 I PAINT ALL MY ENGINES WITH IT-for about 6 years now.I paint mine with a brush it will paint 4 engines 2 coats -I want uses anything but this paint-I painted the 63 nova engine with it check it out|
|03-02-2013 10:24 PM|
|03-02-2013 07:21 PM|
Engine parts get pretty warm on a bike, so need to use the proper paint or it will flake off.
|03-02-2013 07:17 PM|
|This thread has more than 15 replies. Click here to review the whole thread.|