Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> sludged up mopar 218?
User Name
Password
lost password?   |   register now

Thread: sludged up mopar 218? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-11-2012 05:19 PM
LATECH Running kerosene or diesel in the engine while running is sure to wash the bearings out of the motor.
If it were mine , I would pull the valve cover, and vauum....YES Vacuum the sludge out of the top of the engine.
Then pull the pan and clean it out along with the pickup screen.
Put both back on, pan first, the pour oil over the valve train, and then put the top cover on, oil each cylinder, and crank the engine over with out the plugs in, so it spins as fast as possible.
When it pressure up, screw in the plugs, prime the carb, and you should get some action
You will need to use a synthetic oil or a conventional oil with a ZDDP additive in that oldie but goodie.
10-11-2012 01:44 PM
TWX I've heard of people putting transmission fluid into the crankcase for a very, very short time to use it to break everything up and then drain it, but I've never personally tried it.
10-11-2012 12:15 PM
xxllmm4 If your just looking for an easy might work kinda thing you might try soaking/flushing it in kerosene. If the engine is that slugged up it might be too late anyway. It really depends on how much time you want to spend on it and if you want to take it apart and clean it right.

If you do get it running I would run it with diesel oil. Diesel oil has more detergents to clean your engine and keep it clean. You can also run a quart of Marvels Mystery Oil in the engine, I personally only do it for a few hundred miles, MMO is thin and will evaporate more than normal engine oil but it cleans good.
10-11-2012 11:54 AM
vinniekq2 Its a crap shoot at best.I guess decide if the engine has a value then proceed from there. If you dont care then flush it out,put in new oil and try to start.If you care,remove,take apart,clean check and repair/replace as required.Its probably full of sludge from the top down. It might run ok?
10-11-2012 11:35 AM
10Tonhammer
sludged up mopar 218?

I'm in the process of reviving my 52 dodge. The block code says its a ply 218. I put a battery in it and removed the seized water pump pulled the plugs and cranked it over. After cranking it twice about 10 secs or less it wouldn't build oil pressure. I pulled the oil filter which was stuck do to sludge in the bottom of housing the scooped some out thick as tar. Then. I drained the oil pan flowed good for a couple of seconds then chunks of sludge were dripping out. I think the lack of pressure is do to this build up what can I do to clean the inside of engine I ponder filling the crankcase with tranny guild to break up the mess and draining again. I can pull the pan just wondering what your thoughts are. Thanks.
Kris.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.