Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> building a 327, need advice
User Name
lost password?   |   register now

Thread: building a 327, need advice Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-21-2012 11:39 PM
vinniekq2 v8 rx7.if thats where the engine is going,P.M. me.Im an RX-7 fan and would like to hear what you used and results
10-21-2012 11:25 PM
building a 327, need advice

If all the clearances have checked out, follow ARP torque specs and directions with lube and sealer. Apply lube on all washers and bolt thread that do not go into water jacket. Apply Permatex teflon sealer to any bolt thread that go into a water jacket. The torque for the main bolts and head bolts is 70 ft. lbs. and rod bolt torque is 55 ft. lbs. unless stated other wise in your kit.
10-21-2012 08:53 PM
vinniekq2 What are you worried about? use all the correct lock tite and lubes,make sure clearances are all correct.Put a decent solid cam in that puppy and bounce the tach off 7k.If its mild then even less worries....
10-21-2012 08:12 PM
building a 327, need advice

i'm building a 2 bolt main 327 sbc, large journal, that i'm reassembling the bottom end with eagle sir rods with arp bolts and arp main BOLTS not studs. the block has been bored 60 over, honed, decked 10 thou, new cam bearings freeze plugs. rotating assembly has been balanced. this is my 3rd small block reassembly but my first "fancy build" and i've never used arp hardware or lube or anything of that matter. I've already plastigauged everything with the factory main bolts, and the arp rod bolts with no lube, and the specs are great, and i'm wanting that peace of mind with the arp main bolts as well but i don't know what im doing there to be honest and i'm worried that something will change once torqued with the lube. what should i do? also any other random advice about 327s would be appreciated lol

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 10:17 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.