Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> Power steering rack question
User Name
Password
lost password?   |   register now

Thread: Power steering rack question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-15-2012 12:14 PM
sspeedstreet The problem I'm having is the rack needs to be as close up against a component as possible. Where the connections enter the rack is the problem.

Since I asked this question I received an answer on another forum I'll share in case this comes up for someone else. One this rack, anyway, there are two shiny "buttons" protruding through the steel tube 180* apart at the junction point. These position the steel tube to the aluminum housing. They can be pulled out with vice grips with a slight turning motion. There is apparently an "O" ring seal in there, so the tube can then be rotated to any angle. Then redrill two small holes and lightly hammer the positioning buttons back in place. Finis!
11-15-2012 06:47 AM
LARRY BOYD When I have problems like you are having I go with braided stainless lines.They flex and can be routed as necessary.Good luck
11-06-2012 05:35 PM
sspeedstreet
Power steering rack question

Hoping someone here can answer an oddball question. I'm using a 1988 Corvette power steering rack on my project. Would it be possible to separate the aluminum valve body/pinion carrier steel tube extension and rotate them 90* relative to their original positions? The pipes that normally enter the steel tube at the top are really getting in the way of other components. It would be great to rotate them to the front for more clearance.

[SIZE=2][/SIZE]
[/SIZE][/SIZE][/FONT]

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.