|11-10-2012 03:00 PM|
|1Gary||Yepper,Billy Turvitao in front of Carmine's on a Rochester street rodder's cruise wheel standing his nitrous red 442 on it's rear bumper.|
|11-10-2012 02:54 PM|
|11-10-2012 07:49 AM|
|10-13-2012 04:48 PM|
Having owned an airgap. It takes 30 minutes of driving before the intake gets warm enough to drive without off idle engine hesitation. When it comes to carbs, cool fuel is not a good thing, as the fuel tends to change from vapor back to fluid then puddles up. Anything less than 50F or even 60F makes for a long warm up period. I removed that airgap as soon as a could and went back to the regular rpm. I hope you have better results with the airgap than I did.
|10-13-2012 03:32 PM|
|79z28dude||i wanna say thats off union st...N of 104 tward the lake|
|10-13-2012 12:27 PM|
|10-13-2012 08:47 AM|
born and raised..... currently serving in the airborne infantry on ft bragg NC tho... i grad greece olympia in 04
i bet that you didnt see that one coming lol
|10-13-2012 07:35 AM|
|10-13-2012 06:55 AM|
454c10- i actually already have all the parts... i went with the air gap for the the cooler intake temp and also the longer runners. with the longer runners the velocity is increased and thats the main "feature" of the vortec heads. Thats also the reason for the poly carb spacer...
as for the extra fuel cell, i was thinking something very similar to doing that. but i was curious just a electric fuel pump in there? and it only turns on when you arm the system?
|10-13-2012 06:43 AM|
when i got it... it ran a 13.8....id like mid- high 12's...later today im putting the new top end on....
gary on a side note, when was the last time you had a garbage plate from nicks?
|10-13-2012 06:38 AM|
|1Gary||What is your goals at the track??.|
|10-13-2012 06:34 AM|
If you haven't purchased the air gap already, then don't. Get a regular RPM intake instead, as it will have much better street manors, especially in the cooler months.
Same for the carb. Get a holley 3310 750 instead if you haven't purchased the 670 yet.
Plus the 3310 and the regular rpm will be much cheaper.
100 shot should not be a problem. Retard the timing a few degrees and make sure the n02 system has a separate fuel pump. Setup the activation switch for full throttle.
On my n02 setup, I used a 1 gallon fuel cell mounted in front of the radiator and ran racing fuel for the n02 fuel enrichment. Just an idea.
Your 383 should make 400hp and close to 500 ftlbs of torque.
|10-12-2012 09:59 PM|
|10-12-2012 08:48 PM|
|vinniekq2||like OB said,the ring end gap needs to be increased. The 100 hp NO2 shot will increase your torque by closer to 200 pounds.If you have 450 pounds of torque now, then think what 650 pounds of torque will do?|
|10-12-2012 08:07 PM|
wow... when i bought the car thats what came in it according to the build sheet... i know it was a basic rebuild.... and i planned on spraying it once in a while at the track...IE once a month
tomorrow ill add the part numbers from the build sheet
|This thread has more than 15 replies. Click here to review the whole thread.|