Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> engine miss
User Name
lost password?   |   register now

Thread: engine miss Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-17-2012 09:41 AM
db flyer Thanks for the reply. Ya, I was wondering about the Skip White distributor and if
The pickup assembly or something in the other parts could disentegrate the rotor button and cause a miss or burn a plug wire. I read the article you sent on HEI dist. and noticed it mentioned to not go over .40 on plug gap. I have them gaped at .45 and they may be .46/.47 by now. Thanks for any help or recomendations on my situation.
11-16-2012 11:33 PM
vinniekq2 do you have an inductive timing light?
did the 283 go in as an upgrade from the 265?
11-16-2012 08:52 PM
engine miss

You can use a multi-meter or ohm meter to check spark plug wires. Hold a lead to each end of the wire, set the switch to ohms. If the wire is good the reading will be 0. The distributor that Skip White sells is made by ProComp. Do a search on this site on ProComp distributors. Their products are not very good quality. Read this article on Hei distributors.
11-16-2012 02:46 PM
db flyer
engine miss

I have a 283ci in my 56 chev. and put in a small HEI distributor from Skip White,
It has been working fine for about 1500 miles, but developed a miss. I started looking around for something obvious and took out all plugs & cleaned them, then looked in dist. cap for carbon tracks, I noticed the button in dist cap was disentegrated. Skip White sent a new cap and rotor, but still have a miss. I have never had a rotor button disentegrate before. and I wonder if the button left carbon on magnetic assembly in dist. or somehow burnt out a plug wire or?
With these HEI plug wires, can a person just do a continuity check on them with these little volt/continuity testers or hows the best way to test them?
Any help welcomed. I dont know much about these HEI sestems. PS. these small base HEI dist. uses an external coil. Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 10:53 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.