Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Molding fiberglass skirts with 3M 8115
User Name
Password
lost password?   |   register now

Thread: Molding fiberglass skirts with 3M 8115 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-17-2012 03:07 PM
69 widetrack Your teacher should have been more upset about the aluminum dust, alzheimers related problems with aluminum.
11-17-2012 03:03 PM
69 widetrack Actually it's aluminum based and uses fiberglass resin, the off gassing comes from the aluminum...metal to metal is the same principal as a product called aluma-fill. Like all Ski-do's are snowmobiles but not all snowmobiles are Ski-do's.
11-17-2012 12:56 PM
mitmaks Isn't metal-to-metal a fiberglass based body filler? That's what my auto body teacher said. He was mad when I've used it in shop cause of "fiberglass dust everywhere"
11-17-2012 12:53 PM
69 widetrack I wouldn't use the metal to metal, the off gassing of the metal to metal on fiberglass could bubble down the road, I'd use short strand fiberglass by evercoat, more compatible with both surfaces.
11-17-2012 12:44 PM
mitmaks I think I'll use Evercoat metal-to-metal body filler on the joints
11-17-2012 12:42 PM
69 widetrack Are these skirts permanent? If they are and you want to bond fiberglass to metal, then yes 3M's 8115 will work...Just be sure to finish your lap area with fine paper (I finish mine in 320 before priming) and allow plenty of cure time for the panel bonding adhesive...give it extra cure time...if not, I've seen the bond line come back and be quite visible in time after it's painted
11-17-2012 12:19 PM
mitmaks
Molding fiberglass skirts with 3M 8115

Would like to mold some side skirts on a car. Can I use 3M 8115 to mold these fiberglass skirts onto steel body?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.