|11-18-2012 09:55 PM|
All the good stuff gone
Show someone it's running then take off all the good stuff $300 is more then fair!! my new 2 cents!!
|11-18-2012 08:45 PM|
thaks guys i put it up for sale now so potential buyers could hear it runin the car / go for a test drive if ti dosent sell before i pull it ill build a lil engine stand it can be run on.
only thing i dont have paper work for is the rods , but it is obvious if u pull the pan off
if the engine dont sell ill prolly drop it in my silverado 2500 with a milder cam
|11-18-2012 09:00 AM|
|monster76||you can weld right? Just build a little stand out of steel so you can start it on the stand|
|11-18-2012 08:57 AM|
i kinda agree with gearhead
hearing it run is big... i'd never put that money into a motor i can't hear.. but if u want to pull the pan and ck the bearings???
U BETTER B BRING'N A PAN GASKET TOO... or no dice..
|11-18-2012 06:26 AM|
unless you plan on getting 300.oo I'd leave it in the car so the buyer can hear/see it running..
low miles or not.. if I can't see it run.. it's a core as far as paying money to buy it..
receipts for the parts/machine work will help..
1200.oo isn't out of line if you have proof of the work and parts..
but at 1200.oo I want to hear it run.. and be able to pull the pan and look at a main bearing..
|11-18-2012 01:41 AM|
|Project89||i guess i should have added its in a 0010 4 bolt block .030 over|
|11-17-2012 10:52 PM|
im going to be pulling the engine out of my twin turbo iroc soon and will put it up for sale on my local forums problem is i dont know how much to ask
its a fresh sbc 355 about 500 miles on it
gm forged crank std/std
gm rods that have been resized shot peened strees relived with arp waveloc bolts
speed pro popup pistons 9.2-1 cr
summit 224/224 cam and edelbrock 234/244 cam edl currently installed
ported 882 heads , stainless valves
port matched tpi intake
i will also be in cluding the twin turbo headers but no turbos or wastegates.
along with that ill be selling ir without injectors
so basically a complete longblock and a set of twin turbo headers
i was thinking around 1,200 bucks sound fair? or is that to cheap/expensive for what it is