|03-01-2013 10:11 PM|
|03-01-2013 06:28 PM|
|evintho||Thanks! The frame design is mine. I copied the outer dimensions off the original subframe (which was a rusty, rotted mess). I Z'd the front x-member 3" and kicked up the rear 13". The rear isn't a 4-link. A 4-link has 2 upper and 2 lower arms. My rear is just 2 trailing arms thats suspended w/coilovers and centered with a panhard bar.|
|03-01-2013 02:46 AM|
|barrnone50||looking good on the your frame! should be a roller soon. I know it takes a while but you can tell you have put a lot of thought into your build. Your frame design is yours or did you get dimenisons from other source? what you did with rear end look pretty clean,would that be considered a 4 link? thanks George|
|02-27-2013 06:09 PM|
Thanks man! The body is on hold right now. I've been concentrating on making it a roller. Got the front and rear suspension hung and most of an x-member built. Right now I'm working on mounting the '40 Ford pedal assembly and master cylinder. Sure is slow going!
|02-27-2013 05:34 PM|
|barrnone50||I like the band saw. But what about a update on the body Doctor? You did a great job on the 1/4s claiming to be a rooky hard to believe after seeing the completed 1/4s. Great job!|
|02-26-2013 10:48 PM|
It works great! It just sits on the floor in a corner and when I need it I slide it out and plug it in. I cut every piece of steel on my roadster frame with it along with a zillion brackets. I'm gonna use it tomorrow when I cut some 1/4" plate to make an adapter for my pedal assembly/master cylinder. I love this thing!
|02-26-2013 04:29 PM|
|machinee||That's really cool! How does your homemade band saw work? Tried making projects using it?|
|02-21-2013 06:03 PM|
|02-21-2013 03:29 PM|
Band saw stand.
I didn't use as much tube -angle iron for mine. No pict . I found that clamping in a vise on the bottom by the trigger will cause it to stick later on, I use a 1 inch wide squeezer spring clamp to hold the trigger on, bent to fit I have an upright tube up the back side and another bracket that clamps it near the top handle. the bottom just rests in a curved piece that matches the shape
|02-21-2013 06:40 AM|
You can buy a new one on Amazon for $15 here:
|02-21-2013 06:07 AM|
|barrnone50||Very Nice job on the band saw! How big of material can you cut,between the blade and the main body of the saw? Band saw is the only way to go with fabing parts,my buddy has a very nice jet saw,but$$$,yours might just fit the bill. Thanks for sharing!|
|11-28-2012 10:35 PM|
|JAllen||Have47nashambassador, need help on 6voltsystem|
|08-18-2012 10:30 PM|
|Grease_Fever||Awesome! Love this kind of ingenuity!|
|08-18-2012 08:44 PM|
WOW.....great project. Great job.
|07-08-2012 03:50 PM|
|This thread has more than 15 replies. Click here to review the whole thread.|