|12-02-2012 09:57 AM|
Nice-looking job there, Lake.
If and when I ever get around to finishing my fleetside, I was envisioning a 1976 suburban tank, and grafting a fuel filler door to the outer panel. The suburban had about the same width on the frame rails, I think
It would likely take a bit of work to build in some kind of pocket or cover for the filler neck.
Spectra Premium # GM15A
Gas Tank Capacity : 25 GAL; 95 l
Gas Tank Height : 28 3/4"
Gas Tank Length : 28 1/8"
Gas Tank Width : 10 3/4"
I couldn't read your dimensions in your diagram.
Does this sound close?
|12-02-2012 09:34 AM|
I isntalled a "Tanks, Inc." '49-'52 Chevy passenger car gas tank behind the rear axle.
Here is a thread I created that gives the basics: Rear Mount Gas Tank 63-72 Short Bed Step Side - ChevyTalk --The Social Network for Chevy Fans
I am runing a carb so I am using the regular mechanical fuel pump. However, Tanks Inc. also has an in-tank fuel injection pump that will work with their tanks. In-Tank Fuel Pump Module - GPA-Series
|12-02-2012 08:47 AM|
NAPA (Airtex) #E8228 with 5/16" fittings
I filtered the list down to what I think might suit your needs.
I see that Summits also stocks the same Airtex fuel pump part numbers that I provided above.
You'll also want a fairly decent in-line fuel filter between the tank and the pump.
|12-02-2012 08:20 AM|
65 C10 fuel tank
Check out this tank. EFI or carbureted applications. 1965 CHEVROLET C10 PICKUP Classic Performance Aluminum Gas Tanks 6372AGTBS - SummitRacing.com
|12-02-2012 07:53 AM|
RPM or ron pope motorsports makes them..
he's in kodak TN.
tell him delaware bill sent u...
no i do not get any kick backs, i just know he does tanks..
|12-02-2012 07:16 AM|
65 C10 fuel tank
Hi i got a 65 c10 and i want to put the fuel tank in the rear. Im putting a 6.0 vortec in which needs 55-60 psi fuel. is there a company that supplies tanks with pump assb in them at that psi.or a good frame style pump anyone recommends