Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Trans not going into gear cold
User Name
Password
lost password?   |   register now

Thread: Trans not going into gear cold Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-07-2012 01:17 PM
spinn Yes that was my guess. Thinking the slave was short or plate had the fingers pressed in after 100k. I checked the clutch fork travel in the inspection hole under the battery, when I bled the system. For 6 inches of travel it needed .5 of fork movement. It checks good. That does not account for bent or sunken fingers on the pressure plate.

Looks like Im going in, because you cannot diagnose further without opening it up.

No inspection cover.
12-06-2012 10:37 PM
C-10 Binding pilot bushing or bearing.

Oiled down clutch disc.

Not enough throw for the pressure plate.

Pressure plate partially collapsed.
12-06-2012 01:25 PM
spinn It is a 5 speed FWD. Dextron 3 ATF was changed, and is what the manual calls for. That is what was in it before too.
12-06-2012 01:18 PM
prostreet6t9 Which trans? What oil are you using now?
12-06-2012 01:12 PM
spinn
Trans not going into gear cold

My brothers car has a manual trans problem. The shifter will not go into any gear cold. When hot it shifts into gear. When it is off it shifts into gear cold. I have checked the fluid. It is new and proper level. I checked the clutch master and slave, and bled it to be sure. Thinking the plate was not disengauging from the flywheel, or that the master didnt have enough force to. Nothing replaced but it seemed the linkage was working. If I leave it in gear over night, start it, I can drive away. If I stop it will not go back in first till warmed up. If this was the synchro, would it not go into gear cold , engine off, like it does? The clutch holds and will stall the vehicle. I am not the trans master , but this has me . Any ideas on what this could be?

Now that it is cold it has become a serious problem. Warm it drives real nice.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.