Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> General Rodding Tech> Oil pump for transfer case/rear end.
User Name
Password
lost password?   |   register now

Thread: Oil pump for transfer case/rear end. Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-10-2012 01:29 PM
cerial Currently I am torn between tilton or the more expensive weldon. But, I am open to others.
12-10-2012 01:26 PM
cerial
Oil pump for transfer case/rear end.

I am looking for a pump to use with my transfer case. The transfer case (designed by me and perfected by SCS) is basically 2 spur gears on two shafts inside a beefy housing to reverse direction of my rear engine build while giving awd. So you may compare it to a rear end in many cases in the relation to the temps.

The layout is transfer case, inline temp gauge(at lower pickup location), inline thermostatic switch (180F on 165F off), filter, cooler, pump, then case sprayer. When the switch is tripped the pump and fan will kick on at the same time using independent relays.

Any recommendations on pumps and for that manner oil to use with these pumps. The transfer case also gives a .75/1 output ratio. The rpm range of the input gear is 1500 to 5000 practical with 6500 being the rev limiter. Note that the output gear will be spinning 25% faster then the input gear. The application is daily driver with highway speeds and long range trips in the works. This will be used in temps ranging from -30F to 100F.
Thanks for any info

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:59 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.