I just replaced my transmission pan and Seal and put 5 qts in it I also let it worm up and put it through the gears and it shows up just above the add mark on the stick do I need to put a 6th qt in
Ok I will do thanks I aslo have another question the new pan and seal are still leaking not bad I tightened all the bolts n don't know were to go from there
your talking about the pan gasket . correct .. never over tighten the pan bolts.
I can't see the pan gasket leaking unless was installed with a sealer on it .. I use 3M spray glue on the pan side of the gasket .. let it tac and put it on .
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.7K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!