Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 94 corvette
User Name
lost password?   |   register now

Thread: 94 corvette Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-29-2012 07:07 PM
LATECH Like I allways say...check the basics.
Fuel pressure check the prime pressure.
Check for spark at the plugs
Check for injector pulse
No spark and no injector pulse is usually a crank sensor.
You can also pull trouble codes from the PCM, get history codes. If no history codes ...look for any pending(one trip) codes.
Post your results here...I will help you out.
You dont want to castrate that car by putting on a carb.
If you vette has an OBD 1 connector instead of OBD 2, you can get flash codes (check engine light) with a jumper wire in the diagnostic connector.
12-29-2012 06:53 PM
Originally Posted by D.W. View Post
any one know if i can change the top end to my vet to carb and intake to get the fuel injetion off the car it want start any more
How do you even know if the FI is the cause of the no start condition? It could be something different or if caused by faulty FI, a simple fix.
Hcompton has it nailed
12-27-2012 07:27 AM
OneMoreTime Frankly a lot of guys who are in the know and who have taken the time to learn the systems are moving to computer controls for better fuel management and performance. So hit the books and study the workings of the system and fix what you have..

12-27-2012 07:04 AM
vinniekq2 My sons father in law has a 94 vette.It has the LT-4 engine.If you have this option,fix it.If you manage a carb conversion,you will lose a lot of power/mileage and drive ability
12-27-2012 05:24 AM
Originally Posted by D.W. View Post
any one know if i can change the top end to my vet to carb and intake to get the fuel injetion off the car it want start any more
Sure can but its not easy. I did it with my 89 vette. But in a 94 it will cost more to remove than to have the dealer fix any issues.

Here are some of the gotchas

Trans in 94 is computer controlled.

Fuel pump 94 engine may not have machanical fuel pump area machined or no rod or lobe on the cam. Also the computer runs the fuel pump.

Speedo and dash cluster

Ac controls are powered by the computer and usally have issue working without it. My 89 only has no light now but other years have different issues.

You will need to buy intake for lt1 not gen one chevy engine.

I think the alum block lt1 is low tension piston rings with the rich carb these rings wont be happy and engine wont last as long as with efi.

Basicly without the computer most of your car will not work. Almost everything inside and your car has traction control and abs so a lot of important features will be unrepair able.

With an 89 where it is tpi and no power is going to be made with it then replacement makes since but with the lt1 manifold alot of power can be made with cam change, injectors and new tune and exhuast. Getting it fixed should only cost a few hundred bucks. Getting it fully replaced will cost into the thousands once all is said and done. Unless you are good with computer dash ssytems i would just get it fixed. also it does kill the value of a corvette not to have its original dash. My car had the benifit of having gone 300k miles so no one will buy it for collector value. Your 94 may still have some value on the stock form.

Fix it sell it and buy an 80 stingray. Then go ape with anything you want. It will actually add value to an 1980 but a 94 it will take away value. If that makes since. The 80 is already carb and everyone is happy not to see a computer controlled carb on a gm car. When they pop the hood. With the 94 they will not want to buy it once its that far gone.

When I did mine I replaced the engine and trans. With a older version of both none computer th700r4 and a gen one block that i rebuilt for carb use.

Fyi only the edelbrock performer and torker II will fit under the stock vette hood for the most part no good intakes fit the vette without larger hood or cutiing a hole in it. Also the performer is stock replacement manifold not real good power. The torker will make some power but will still be less than a proper manifold.

What is wrong with it. If it wont start that is usally an easy thing to fix. Running poorly now that can be hard to track down but they usally start even of they are messed up. Probably the fuel pump or fuel pump relay. Might be an easy fix.

Hope this helps.
12-27-2012 04:30 AM
94 corvette

any one know if i can change the top end to my vet to carb and intake to get the fuel injetion off the car it want start any more

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 01:36 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.