Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 383 stroker assembly
User Name
Password
lost password?   |   register now

Thread: 383 stroker assembly Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-31-2012 07:30 AM
Balls I have built several 383. Something to watch out for Is the cam lobes may clear the rod bolts During your mockup assembly but after degreeing in the cam the lobes may hit.( most commonly on number 5) be sure your cam is degreed where you want during your mockup so you dont get a nasty surprise during final assembly.
12-31-2012 06:32 AM
Gus's 40 I use the same bearings its going to run and I do lube all the bearing surfaces, you will want to thoroughly clean everything, allot!!!
12-30-2012 05:39 PM
377MONTE Is it alright to use the same bearings that I will be using in the finished product or do I need to find some throw away bearings to use for the mock up and cutting?
12-30-2012 05:38 PM
377MONTE so obviously the cam needs to be installed during the mock up to check cam to rod clearance, but can the cam be installed without assembly lube? The lube would throw off my measurements, right? Also, do the bearings need to be lubed up or will they be fine dry since you are only turning the motor over by hand?
12-30-2012 05:33 PM
Gus's 40 the last couple I assembled I had to remove some material from top of the rod bolts to clear the cam, both blocks were lined bored, and one of them the bottom of the block where the oil pan goes needed a little room. I used plumbers putty on the rods and made sure I had at least .060 clearance
12-30-2012 05:20 PM
377MONTE
383 stroker assembly

Alright guys, all the pieces and parts have arrived and I am ready to start the mock up assembly of my 383 to make the required clearances. I need some advice on the details..

Can somebody please break down the steps of the mock up assembly in detail? I have the basics down, just want to make sure I have all the details down pat too.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.