Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Intake question....Vic JR or Air Gap RPM
User Name
Password
lost password?   |   register now

Thread: Intake question....Vic JR or Air Gap RPM Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-21-2013 08:38 PM
hcompton I think the cam is a littlw small for the jr maybe just border line. But makes the air gap a good choice. They are not perfect many say its very close the the jr either way. Might loose tq and hp either way performer rpm is a good manifold i would not be suprised to see the regular rpm hit the mark better than the air gap.
01-21-2013 06:46 PM
abritton77 I was thinking the rpm airgap was the way to go myself.

Hey Fbird, what kinda 60' time are you cutting to pull the tires off the ground? just wondering about how much I need to do the same.
01-21-2013 11:01 AM
malc
01-21-2013 09:17 AM
vinniekq2
01-21-2013 08:31 AM
vinniekq2 there is a possibility that fb88 is correct this time?

On my Camaro I took of a performer and installed a vic junior and picked up 4/10s.
I was using a solid cam and 830 holley,stockish cast iron heads
01-20-2013 10:27 PM
vinniekq2 I use a jr on my car.if you make power and want more the answer is clear.I have no issues with torque
01-20-2013 07:30 PM
abritton77
Intake question....Vic JR or Air Gap RPM

I am upgrading my 383 sbc and unsure of which intake I should use. It is 10-1 comp with edelbrock e210 heads and a comp roller cam 235@.050 and 565 lift. I have both intakes and plan to sell one. This is a street strip car that is for fun only. I would try both but this is in a 98 Camaro and to change the intake involves dropping the motor out of the bottom of the car. I am leaning towards the air gap cause I do not want to loose my low end torque. For the record, I have a 3000 stall and 3.73 gears.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:56 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.