Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> General Rodding Tech> Sebring 1st vs. 2nd gen seats with shoulder belt ???
User Name
Password
lost password?   |   register now

Thread: Sebring 1st vs. 2nd gen seats with shoulder belt ??? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-26-2013 07:32 AM
DanTwoLakes Moving this thread to General Rodding Tech.

Dan
01-26-2013 07:21 AM
waid302
Sebring 1st vs. 2nd gen seats with shoulder belt ???

I recently purchased pair of Sebring Seats for my 64 Ford from my local pic-a-part. Up until now, I did not know that there was a module that I needed which I did not get! With first generation I believe when the solenoids are powered, the seatbelt can be moved. When the solenoids are not powered, the seatbelts cannot be moved.

http://www.corvairkid.com/sebring.htm

I think my seats are 2nd generation. I am able to move the belts on both driver and passenger side with no power connected. When I can jerk the seat belt, they seem to lock fine without any module. From what I found so far, beginning with the 2001 model year, the Seatbelt Control Timer Module (SCTM) was eliminated and the electronics were fully integrated with the airbag controls into a unified occupant restraint system. The seats do have pyrotechnic pre-tensioners which I have left disconnected.

It appears that the module with 2001+ seats only controls the pyrotechnic pre-tensioners in the seat itself + the air bags.

Does anyone know even if I get the module, it will not work without all of the impact sensors and stuff. Correct?

Is there any issue with my seat (2001+) operating properly without the module & leaving pyrotechnic pre-tensioners disconnected?

Can I replace the pyrotechnic pre-tensioners with 1996-1997?

waid

Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:23 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.