Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> daily driver? toyota pickup w/ 400sbc
User Name
Password
lost password?   |   register now

Thread: daily driver? toyota pickup w/ 400sbc Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-31-2013 09:10 AM
matt167 Says lincoln locker, so no I would not drive it on the street.
01-31-2013 07:59 AM
NoEngrish thx for the comments, but yea, too much work and i need a daily driver. Alberta has winter for 8 months. I'm going into field work as a welder and i need a car, so i bought a 1999 subaru impreza 2.5rs coupe with a complete wrx swap for my new dd =D much more reliable
01-30-2013 11:28 PM
vinniekq2 If you use a toyota transfer case then gears do not matter for off road as you can stack them and low range is 3:1. Just worry about whats good enough on the street
01-30-2013 10:40 PM
prostreet6t9 A SBC toyota with 38's wont need 571 gears unless its a "mud only" truck. Also the 529 and 571 gear set's are known for tearing up the gear sets. 488 or 513 ratio should work well.
01-30-2013 08:19 PM
techinspector1 TH350 with 1.0 3rd gear, 38" tire, 4.37 rear gear, 2500 rpm's = 64 mph.
TH350 with 1.0 3rd gear, 28" tire, 3.25 rear gear, 2500 rpm's = 64 mph.

TH350 with 1.0 3rd gear, 38" tire, 5.71 rear gear, 3250 rpm's = 64 mph
TH350 with 1.0 3rd gear, 28" tire, 4.18 rear gear, 3250 rpm's = 64 mph

If you used a 28" tire and a 3.25 rear gear, you would make the same speed at the same rpm's that you would if you used a 4.37 rear gear and a 38" tire. Now, if your truck did have 28" tires and a 3.25 gear, you certainly wouldn't install a "big" cam and expect it to perform correctly. You would add more gear. Let's say that you changed out the 3.25 cogs for a set of 4.18 cogs in order to "get up on the cam". I'm fully aware that there are no such cogs available for your differentials, I'm just crunchin' numbers for you to show you that you will need more gear with those meats. In order to have the same speed and rpm as you would with 28" tires and a 4.18 gear, you will need a set of 5.71's front and rear. Yes, that is a real gearset for a Toyota differential.

You don't have enough gear to run a "big" cam.
01-30-2013 07:49 PM
vinniekq2 I know you did,but I dont know the OP so I should behave.
There seems to be quite a few land cruisers with sbc conversions and a bell housing is available to use the Toyota transmission
01-30-2013 07:29 PM
68NovaSS Didn't mean that, I said it with tongue in cheek, lol.
01-30-2013 07:15 PM
vinniekq2 No Engrish,I apologise,couldnt resist though
Thanks 68novaSS for putting me in my place
01-30-2013 06:58 PM
68NovaSS Toylet??? That's sooo bad Vinnie!
01-30-2013 06:34 PM
vinniekq2 what do you call the beast? a chevota or Toylet?
What part of Canada is winter 8 months? The 400 is a decent engine and if the person that built it used good parts then,drive the wheels off it
01-30-2013 10:55 AM
NoEngrish
daily driver? toyota pickup w/ 400sbc

hi i'm new to this forum and new to all of this....
i just want some opinion on a truck i want to get
it's a 1985 toyota pickup with a 400 sbc
has a 6 - 10 inch left

engine has
-202 heads port and polished
-larger stronger valve springs
-roller rockers
-5 angle valve job
-edelbrock performace intake
-holley 770cfm truck avenger carb
-extreme energy comp cams unknown size but it's big

heavy duty turbo 350
208 transfer case
hooker headers
38" 15.50 r15 TSL boggers
b&m rachet swifter
4:37 gears with front open and rear end lincoln locker
electric fuel pump
rad is in the box
2" wheel spacers


i live in canada and it's winter for 8 months, i just want to know if this will be okay as a daily driver mostly in winter when it's -30 outside. i have a 500whp subaru sti so i dont really care about fuel mileage

thanks for reading any comment will be greatful

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.