Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Holley two barrel on a chrysler 318 problem
User Name
Password
lost password?   |   register now

Thread: Holley two barrel on a chrysler 318 problem Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-09-2003 09:42 PM
Robinson Robin The 318's use a smaller bolt pattern for the carb I ran into the same problem. you can get a 2 barrel from a 360 and it will work with the carb but the ports will be to large to match up to the heads very well and it will hurt flow. I think 4 jaw is right you may have to go with a 4 barrel and adaptor to use the holley. Another way is to get 360 heads too but unless you change the pistions you will have a low compression ratio because they have more volume.
10-09-2003 04:42 PM
4 Jaw Chuck You will probably have to purchase a four barel intake and then buy an adapter plate to convert from to four to two. I would recomend a smallish dual plane meant for economy. I'm not really fond of the adapter plate idea but it works, why not rebuild a Carter and use it? Lots of two barrel Chryco intakes out there that take a Carter two barrel, for the price of the spacer you could almost buy a used carb and intake plus a rebuild kit for the two barrel carb.
10-09-2003 04:25 PM
powerwagon
Holley two barrel on a chrysler 318 problem

Recently I went to swap out a carter BBD 2 with a two barrel holley 2300-7448. The vehicle I am doing this to is a 1977 dodge power wagon with a stock 318 and an automatic tranny. It was no suprise when I realized I need to change the intake for it to fit, however I have no idea which intake to get. I tried to find something in Summit racing, but they (and many other sites) only carry four barrel intakes. I need to know what kind of intake can accomodate a holley two barrel and where I can get it.
Thank you.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:12 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.