Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> Cutting Leaf Springs
User Name
Password
lost password?   |   register now

Thread: Cutting Leaf Springs Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-12-2013 07:29 AM
timothale
wet cut

A lot of times I use a spray bottle with water to cut stuff with My old 220 V belt drive chop saw. when I don't want to ruin the temper.
The wet grit and metal will set up like cement so clean it off before you need a jackhammer to get the big clumps off.
You can reshape leaf springs to get ride height. I used my harbor freight pipe bender, with just the pins, no rollers. Chalk the pattern you want for the bend, mark the spring an inch apart them just slide it along putting a little bend at a time and work it back and forth. Watch the far end of the spring as you bend Just tweek it a little. Those kits are way too expensive for what you get. , some spring shops can re-arch your springs. but I do most of the stuff myself.
02-12-2013 07:27 AM
azlogger Thank you. and yes i do have a chop saw.
02-11-2013 05:09 PM
MARTINSR Don't have a chop saw? A die grinder with a cut off disc will do it too. If you don't have one of those I say go buy one, one of the most useful tools you could ever have around the shop.

Brian
02-11-2013 05:06 PM
Mad Tiki Customs You can use a chop saw. Just dont go all gorilla on it. Let the blade do the work and you'll be fine.
02-11-2013 04:46 PM
azlogger
Cutting Leaf Springs

I need to cut a set of leaf springs in half to make quarter elliptic springs for my car.
what do i use to cut these? i'm afraid the springs will be hard on bandsaw blades, and i thought a chop saw might make them too hot and either lose the temper or at least stess them... so how is it done?

thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.