|02-18-2013 05:03 PM|
Might as well get it over with...
|02-18-2013 02:34 PM|
Starting to sound like trash or wear causing binding, TV valve/sleeve maybe.
If it does it again, disconnect the TV cable, engine running, E-brake on, snatch cable a dozen or so times & reconnect.
There's also a Governor screen under the Valvebody at rear that can cause problems if restricted.
|02-17-2013 08:01 PM|
|Slammedsi||After letting the truck set for a full 24hrs, I got in to drive it to my shop. To my surprise it shifted... I went ahead and drove around town a for a while. It only hung I gear twice during a thirty minute drive around town. I'm so lost on what is causing this problem. Suggestions are very welcome at this point...|
|02-16-2013 04:40 PM|
Ive checked to make sure there wasnt any slack. There isnt any. Readjusted the TV cable one more time for good measure.
Still not wanting to shift unless its really hi in the rpm range, Or at WOT. Is there anything else to check before i move on to pulling this unit and installing another one.
|02-16-2013 07:36 AM|
|02-15-2013 10:40 PM|
|SSedan64||If it's not what Crosley suggested, it may be a problem with the Governor.|
|02-15-2013 08:15 PM|
|02-15-2013 07:45 PM|
Does the cable have any slack in it with throttle at the closed position?
If the minimum cable setting is not enough, the trans will go into "fail safe " mode IF the fail safe check ball is installed. This fail safe mode will cause high RPM shifts like WOT and the shifts will be firm.
You may also have a worn out valve bore for the TV valve in the valve body. Oil pressure can get behind the inner TV valve and force it over to MAX stroke... that will also cause late - firm shifts like a WOT
|02-15-2013 02:24 PM|
|Slammedsi||I adjusted the TV cable per a source i found online, and it still doesn't want to shift unless its near the top of the rpm range. Unsure where to go from here. I have a newly rebuilt trans laying in my shop, but don't want to change it out unless it has to be.|
|02-14-2013 02:24 PM|
|38Sedan||Not only that it will burn up the transmission in a hurry if it is not correctly adjusted. There are several sources on the internet that sell the proper brackets etc.|
|02-14-2013 12:39 PM|
Inquiring about 700r4 tv cable
Will a incorrectly adjusted tv cable cause the trans to only **** up to the next gear at or near wot, and higher in the rpm range?