Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> installation of wilwood rear disc brakes on 9 in. ford
User Name
Password
lost password?   |   register now

Thread: installation of wilwood rear disc brakes on 9 in. ford Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-16-2013 08:35 PM
aosborn The bracket doesn't go between the housing and the axle flange, it goes on inboard of the axle housing flange. As to the recess, I would suspect that it is either to capture the heads of the bolts so they don't spin while tightening the axle retainer nuts, or it goes toward the outside so the caliper centers over the rotor. It should be easy to figure out by just mocking up the parts. When installed properly, the bleeder screw on the caliper should be up so air cannot be trapped in the caliper.

Good luck

Andy
03-16-2013 02:48 PM
wheel-7
installation of wilwood rear disc brakes on 9 in. ford

I have a couple of questions concerning Wilwood rear disc brakes on a Ford 9 in. rear that I hope I get someone could help me with.
1. On the " U " shaped calipher mounting bracket there is about a 1/8 recess machined into the bracket on one side( follows the contour of the axel) . On the other side flat and smooth. Is the recess side of the bracket mounted toward the center section or towards the wheel ?

2. I have a " full circle axel retainer " The retainer is really oblong but they called it a full circle retainer. Does the " U " shaped calipher bracket fit over the axel retainer or under it ? In other words, do you mount the " U " shaped calipher bracket on first then put the axel retainer on or vice versa ?

Any help would greatly be appreciated..I checked the Wilwood web site but they didnt go into that kind of detail.

This maybe to much to ask but pictures of diagrams would help a lot.
Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:03 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.