|03-20-2013 08:05 PM|
|Cape Cod Bob||Very good ans very reasonable. Just be sure you are on the same page with the length. I downloaded Denny's printable diagram on how to measure. Helped a lot.|
|03-20-2013 09:13 AM|
Thanks for all the replies!
Going with "south shore bearing "....very well recommended, and very reasonable.
|03-20-2013 09:06 AM|
Call Magnus Racing Products in Danielson CT. He has PST (?) driveshafts; all new steel, 3" dia I believe; comes with new U-joints and a yoke. If you need a custom length; he'll order it for you. Expect it to be in the $200-$250 range. When you call; ask for Mike Sangermano. Tell him Nate from Auto Gear gave you his name
Mods: can I post the phone number?
|03-19-2013 02:56 PM|
they used my old just for measurment.. nothing old used.. no need to get from an out of state shop.
|03-19-2013 01:14 PM|
Your alternative is to find a shop that does truck driveline work, bring them a rusty and pitted junkyard drive shaft, a well used input spline and let them try to make the yokes that may be distorted work, then add someones unknown brand u-joints, balance this claptrap and pray it's going to be a good deal for you.
Universal Auto, N. Pearl Street in Albany NY will do a decent job for about $225+/- using your junk yard parts and new Spicer u-joints and is my usual alternative to Denny's, having made up several for me in the past.
|03-19-2013 01:02 PM|
my shaft took dual shots of happy gas and high 9's
and they are local
|03-19-2013 11:52 AM|
|31ROC||Whoah.....your right about "not cheap"!!!|
|03-19-2013 11:50 AM|
I'll second Denny's Driveshafts - they do nice work and within reason, but not cheap.
This is mine:
|03-19-2013 10:57 AM|
south shore bearing in quincy mass.
I've had 3 shafts made there..
|03-19-2013 10:52 AM|
|33Willys77||Check out Dennys driveshafts. Dennys Driveshaft Street Rod Driveshafts affordably priced and custom built in your choice of steel or aluminum. High Speed High RPM Balanced for smooth running trouble free performance|
|03-19-2013 09:46 AM|
Driveshaft builder? (southern New England)
Can anyone recommend a driveshaft builder--Northern CT/Western Mass areas?