Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> SBC header tube diameter
User Name
Password
lost password?   |   register now

Thread: SBC header tube diameter Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-02-2013 02:45 AM
snakebit68
exhaust

I would advise you to go no smaller then 2 1/2" pipes....and 3" would probably be even better. You're going to need that engine to breathe. The last thing you want is backpressure with a supercharger. I ran a smallblock with small diameter pipes with a blower in the past...I blew it up. It matters more how much you can evacuate from the engine then what you can force into it.
04-01-2013 09:28 PM
vinniekq2 I use 3 inch mandrel bent exhaust with an X pipe,2 1/4 is a joke.
My primaries start at 1 7/8 and step to 2 inch with 3 inch long collectors,my engine is N.A.
You should make more power than me so you need bigger
04-01-2013 09:07 PM
cadillacdave1 What kind of horsepower will it make 650? or more. You need at least 1 3/4 or 1 7/8 headers. Get rid of the 2.25 inch with that motor as there is no benefit. You need at least 2 1/2 and better with 3 inch exhaust. The 2.25 wont expel the exhaust quick enough as it starts to build power.
04-01-2013 06:44 PM
DjohnsonFTW
SBC header tube diameter

Im sure this question has been asked before, but ill ask anyhow!!

I have a 400 sbc punched out .040'' making it a 408, I am supercharging it to- estimated 6-8 psi.

After the header collector will be 3'' pipe leading to X pipe with 3'' cut outs. after the x it will drop to dual 2.25'' pipes out the rear.

I understand with cutouts closed im limited to the 2.25'' pipe, but will i benefit from larger headers when factoring 3'' cutouts?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:34 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.