Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Interior> New interior panel recommendations
User Name
Password
lost password?   |   register now

Thread: New interior panel recommendations Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-02-2013 08:01 PM
49willard Dan,
Is the rattle can DAP high strength adhesive suitable for gluing foam backed headliner to my Rod doors abs headliner panel and also for gluing fabric to the foam board that I am going to buy?
04-02-2013 07:37 PM
49willard Dan,
Thanks for the response. I have located a supplier not too far away. 3mm 4 x 8 sheet is $40.
04-02-2013 12:11 PM
DanTwoLakes PVC Foamboard is your best bet. Read this thread: http://www.hotrodders.com/forum/pane...al-225919.html
04-02-2013 11:53 AM
49willard
New interior panel recommendations

I need to make new panels to fabric cover in my 49 Ford truck. The panels are flat (door and kick panels) and some curved (rear quarter panels). I purchased the rod doors headliner panel which is ABS (I think). What is suggested for new panels including bending the quarter panels and who is a possible supplier? I do not have access to anything like vacuum forming and hoped it could be done with a heat lamp or heat gun, comments?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:00 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.