Hot Rod Forum banner

37 Ford Pick Up interior ?

5K views 10 replies 5 participants last post by  DanTwoLakes 
#1 ·
We are doing the interior of a 37 Ford Pick up. The top has been chopped 5 inches. We are looking for ideas for headliner and to wrap the inside of the body on the back. Head space is at a minimum and the seats touch the back of the truck so space is a minimum there also. There are also some fairly complex curves to deal with. We have seen some sort of black plastic board that has a slight texture to it at car shows but we have no idea what it is or where to get it. Any ideas are welcome!
 

Attachments

See less See more
4
#2 ·
I did a '34 Ford truck like this.. The corners are 3mm PVC foam board shaped to fit the cab. The center is a very close fit to the window garnish molding. They are riveted together, covered in 1/8" closed cell foam to level everything out. The roof is a flat piece covered in the same foam.







 
#3 ·
I just finished the interior in my 40' Ford PU,I used a short knapp carpet,(looks like whats in the newer cars,not loop style),and it kinda stretched nice around the trans. tunnel,so I did the cab back panel all the way to the lip above the rear window,to the door opening,no puckers or bubbles,have enough to do the inside the roof,but wasn't sure it would fit the compound curves,so I just painted it with Rustoleum Hammered,they do make a stock "cardboard" hard hd/liner for your truck,maybe just trim it alittle.
 
#6 ·
Are you asking about the photos I posted above? If so, the pvc is the white curved panels in the first photo. It is covered in closed cell foam and topped with black vinyl. The cabs are almost identical, minus the chop on yours. I heat form the pvc just like Dan demonstrates in the thread he linked to.

The pvc foam board is a very common product. You can find it at a plastics distributor or a sign shop. I pay about $26 for a 4' x 8' x 3mm sheet.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top