|04-14-2013 06:42 PM|
Thanks, that's a huge help. I did some more digging (now I know what it's called) and found this TSB that shows were it goes in the case.
I couldn't believe that flimsy little clip would come from inside a trans, I was racking my brain trying to find where it came from. The good news is I don't have to take any more apart than I already have. The only tricky part now is getting the OD piston back in.
|04-14-2013 05:31 PM|
see if this helps
|04-14-2013 05:24 PM|
flat side is against the steel plates edge.. curved humped side is against case.
The folded over ''tail'' end goes away from piston
|04-14-2013 05:20 PM|
|Arrowhead||Ok thanks, that helps a lot. At least now I know it belongs in there, now I just need to figure out how and where.|
|04-14-2013 05:15 PM|
|Crosley||Anti rattle clip for the intermediate clutch pack.|
|04-14-2013 03:32 PM|
4R70W experts-what is this clip?
Long story short, I pulled the pump out to replace the gaskets and seals. It's a 4R70W from an '02 Mustang GT. When I pulled the pump off, some of the packs became misaligned. So I was trying to jiggle everything back into place and this clip popped out:
Any idea what it is? Pretty sure it came from inside the transmission, but I can't find it in the manual anywhere. I already pull the trans from the car and pulled off the valve body and over drive piston so I can get the stack aligned properly, but no sign of where this clip came from.