Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Interior> attach alum door panels and headliner
User Name
Password
lost password?   |   register now

Thread: attach alum door panels and headliner Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-05-2013 07:13 AM
DanTwoLakes The plastic clips do not have more holding power, especially over time. They get brittle when they get older. I use the Au-Ve-Co 12134 clip for door panels, but you're going to have to use something a lot stronger to hold the headliner in with that much weight. This is an offset clip, so the holes in the panels have to be offset 5/8" from the holes in the door. FWIW, the aluminum may have been free, but it's going to rattle, especially the headliner. You may want to re-think this project.
06-04-2013 08:38 PM
26 Stude
attach alum door panels and headliner

What is the best clip to attach aluminum door panels and headliner? I have a 26 Studebaker tudor sedan. My plan is to use .040 aluminum sheets for the door panels wrap them with foam and cloth and use some type of clip to push the panel in place. The same with the roof panel which is a 1 piece alum sheet, I lifted the windshield, curl the panel some what and slide into place. I was going to fiberglass the clips in place on the alum and push the panels on, not that easy. The wire clips I purchased do not have enough strength to hold the roof panel up which weighs about 17 lbs without the foam and fabric. I saw an interior going in this way, well at least the door panels were being done this way, I thought it was a pretty good idea, being the alum was free. Do the plastic Christmas tree clips have more holding power than the wire clips. I like the idea of the alum, then there will not be any roof bows or seams showing. Anyone one else use alum for the panels or should I start over with some thing else?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.