|07-12-2013 07:22 AM|
|07-10-2013 06:44 PM|
There is 2 adjustments on the gun for air and the material..give it more air..if that doesnt work just shoot 3 or 4 coats of clear and the peel will kinda disappear or make it easier to color sand clear..
|07-10-2013 06:41 PM|
You need more at the gun..there is a material and an air adjustment on the gun..give it more air..
|07-10-2013 05:01 PM|
Quarter Panel Repair 1965 Pontiac Tempest
Getting ready to do this as soon as my new garage is built. Lower Quarter Panels are in need of replacing. I have the 65' GTO quarters. I have Duro-Bond also. Trunk also needs panel work. I am open to any suggestions that anyone would have on these type of repairs. To welders, can I use a wire feed welder on the trunk? Never welded before.
|07-10-2013 08:58 AM|
|68dustin||thanks.. I actually played with the mixtures today and it was 100+ out 4:1:1 really layed nice. Just gotta let it flash a little longer and be quicker due to easy to make run.|
|07-09-2013 11:13 PM|
|benchracer1||yes 4 1 1. Disclaimer, I am a novice painter|
|07-09-2013 11:17 AM|
|68dustin||So can I ask a question? what did you end up reducing the paint down to? 4:1:1?|
|07-01-2013 12:21 AM|
|07-01-2013 12:19 AM|
|benchracer1||time to find a harbor freight 20% coupon|
|06-30-2013 08:38 AM|
|06-30-2013 12:38 AM|
|benchracer1||do 3 inch pads fit the Makita 7 in. buffer?|
|06-29-2013 03:04 PM|
|Trucknut||I use foam pads. They come in different grades from heavy cutting down to finish. I switched from 3M to Meguiar's and really like the finish and product performance. One up side to Meguiar's is that AutoZone carries their compounds. That means alot on Sunday when my favorite paint shop is closed and I run out. I run my Makita buffer at about 3 or 4. Also, they make 3 inch foam pads that are great for getting into tight areas and reducing the risk of burning or catching your buffer on something. Just finished a black 69 Firebird. Came out great.|
|06-25-2013 07:32 AM|
I'm finishing up a super straight black job ,I'm getting a little nervous with this one as the time for buffing draws closer.I used to be pretty good but I no longer concider myself an expert its been too long since I had to buff at this level...
I may have to start a thread to reeducate myself...and get some new glasses.
|06-24-2013 06:28 PM|
Hey Mike...I use only foam pads and a couple of drops of water on the foam keeps them from drying out and it helps keep the polish from drying out as well. That's why I use foam, wool, totally different story.
Swirl remover....I hand polish with a micro fiber towel...and a small area, it drying up is a PITA.
|06-23-2013 07:19 AM|
Hey Ray, How do you keep them moist? Buffing sucks and I'm always looking for something to make it easier...
My biggest problem is the swirl remover drying and smuging on the car what a PITA
|This thread has more than 15 replies. Click here to review the whole thread.|