|06-28-2013 05:34 PM|
Info on Pontiac bottle neck studs here.
Other info that you may find useful:
• Adjusting hydraulic lifters
• Cam break in
• Valve train points to check
• Valve train geometry
• Valve spring installed height
• Pontiac info/sites
• Pontiac engine info
|06-28-2013 06:50 AM|
|f/bird||I'm installing cam kit and q/jet with e/b performer intake,timing set,and the cam kit instructions said to replace valve springs so I'll need to do that also .I had not thought about any other parts except the harmonic balancer and water pump .|
|06-27-2013 10:31 PM|
Should be a nice cam for you. Are you using the stock bottleneck rocker arm studs? If so, be sure the preload is correct!
|06-27-2013 09:11 PM|
Pont. 76 350 cam break in procedure
Would like any tips on cam break in for a edelbrock 2157 in a 350 pont. eng. other than the instruction sheet . Any special oil for break-in or for the first run ?