Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 4L60 sliping
User Name
lost password?   |   register now

Thread: 4L60 sliping Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-03-2013 12:42 PM
jokerZ71 I guess it's possible tho.With 4.3 @ closed,the ECM thinks it's almost WOT.Unplug TPS & crank it.It should go into default mode.No signal is better than a bad signal.Don't drive it unplugged.This is just to ck it.
07-03-2013 12:04 PM
jokerZ71 Sounds like you may have shorted out some stuff.I'm not sure,but,the TPS shouldn't be makin it dump fuel.
07-03-2013 11:03 AM
jokerZ71 A bad TPS can cause a series of problems.Hard shifts,no 3rd/OD.Suddenly dropping out of D or OD back to 2nd,no TC lockup & other performance issues.It controls,lockup,shift points,etc.If you probe the black & blue wires with a digital meter,it should read 0 @ closed throttle,then as you open throttle,the reading should increase smoothly with no spikes or flat spots up to approx 5 @ WOT.You can unplug it & see iff trans shifts thru all gears w/o slippage,but'only long enuff for a quik ck.Do not operate vehicle this way.Trans will be operating @ full line pressure.Do not drive any farther than necessary.
07-03-2013 10:44 AM
Originally Posted by lowhirod View Post
will a 1991 700r trany work in a 1995 GMC truck that has a 4L60 in it that slips
I have a new 670 holly TBI and the TPS checks out bad. at idol it reads 4.3 at wot it reads 4.82-5.01. the tbi dumps fuel bad smokes black and the truck will not run unless i pour some gas into the TBI. then it wiil start but when i put it into gear it slams and at about 20 mph the trans. slips. AL THIS CAME ON AFTER WASHING THE ENGINE
07-03-2013 08:25 AM
jokerZ71 Some info for making 4L60E better www.msgpio/manuals/mshift/mods.
07-02-2013 08:59 AM
jokerZ71 Most important thing with a rebuild is to always use a new TC & preferably a new cooler,or,at the very least,completely flush all lines & cooler really good.Auxillary coolers help also.Heat & trash is your #1 enemy.
07-02-2013 08:55 AM
jokerZ71 Burnouts & pulling heavy loads in OD are usually the death of em.There are other things that can go wrong also that can make the trans appear to be bad.A lot of these trans hav been rebuilt due to bad TPS,faulty wiring,etc.It's always best to hav it scanned by a trusted shop befor doin a rebuild.Mine was rebuilt @ 418K & now has 533K.It hasn't been pampered,but,it's been taken care of.Tell me the exact symptoms.Does it do the same thing everytime it goes out?
07-02-2013 08:32 AM
jokerZ71 There are several upgrades to make the 4L60E stronger,but,it'll never be as strong,or,durable as the 4L80E.If it's a 2WD the swap isn't near as bad.Not sure which year model you would need to look for.It is still a lot of work even in the 2WD.What problems exactly are you having with it?You may try a different shop.They usually hold up pretty good for stock vehicles.Mine lasted 418K without any issues.Mudding, occasional truckpulls,& frequently pulling 6,000 lb trailer & horses.
07-02-2013 08:04 AM
99 4l60e

this will be the 3rd time to be rebuilt, thinking time to upgrade to a 4l80e. was daughters go to college vehicle but she was hell on the tans. Any thing to look for year etc to replace it with.
07-02-2013 06:06 AM
jokerZ71 No.The 91 has a TV cable.Your 95 is electronically controlled thru the PCM.Also,95 is a stand alone year for the 4L60E. 93 & 94 will interchange.96,97,& I think 98 will interchange.If buying used or rebuilt,you will need a 95 year model 4L60E.
07-02-2013 05:23 AM
4L60 sliping

will a 1991 700r trany work in a 1995 GMC truck that has a 4L60 in it that slips

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 10:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.