Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> What clearance on rod to crank on rebuild?
User Name
Password
lost password?   |   register now

Thread: What clearance on rod to crank on rebuild? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-04-2003 08:17 PM
nate6201 my book said to check them at differant spots in the cylinder.where there at the closest point file them to fit there.
12-04-2003 07:53 PM
DoubleVision on clearences, anything under .001 is not enough, anything over .003 is too much, just use your piston up side down without the rings on it, push the ring about a inch down in the bore.
12-04-2003 07:49 PM
shockers69
What clearance on rod to crank on rebuild?

I am going to start putting my 350 chevy together and i am reading for the second time David Vizard's "how to rebuild your small block chevy" and it does not tell to check clearances on rod to crank after both rods are on rod journal of crank.It also does not show how far down in bore compression rings should be when checking ring gap.I think in the picture it shows ring gap being checked at top of bore i guess it should be the same throughout bore if machine work was done right.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:50 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.