|10-19-2005 01:56 PM|
|ap72||I just use the regular parts washing stuff that comes in the big metal bucket with a green lid- it works, and that's all I care about. However, if you're in a pinch, I've also used diesel fuel as a solvent, yea its bad for you but a lot of the stuff I do is. It works great and its as close as your local gas station.|
|10-19-2005 11:54 AM|
|JR66Ford||Laquer thinner doesn't work in parts washers. I wanted to use a 5 gallon parts washer as a paint gun cleaner. Put just a small amount of thinner in and watched my plastic pump melt down. Not pretty.|
|12-09-2003 12:43 PM|
long addresses but the first one is a citrus cleaner the second is not citrus based but us biodegradable. Being that they mix with water I am sure they will freeze.
|12-09-2003 10:56 AM|
Where do you purchase these citris cleaners and will it freeze?
|12-09-2003 08:26 AM|
mineral spirits, kerosene, and paint thinner are NOT FLAMMABLE. They are combustibles. You can drop a lit match into a bucket of kero and it will put the match out. But soak a rag in it and put a lit match to it and you will get a nice fire. Now lacquer thinner, gasoline etc is flammable meaning they don't need a carrier(wood,cloth,paper) to ignite. The vapor that these liquids puts off is what burns which is what makes them more dangerous. I would not use mineral spirits as a cleaning solvent in a parts washer. It is not to healthy to breath and you must be careful to properly store your dry off rags. The new citrus cleaners are biodegradable, work well,and are safer.
*bonus*...When you are done you smell like an orchard nor a refinery
|12-09-2003 07:46 AM|
|MI2600||Interesting. I've always used kerosene to clean parts, but w/o the parts washer. I've got a new parts washer in the basement, unused, because I don't have enough floor space left in the garage. Would there be a problem in using kerosene?|
|12-08-2003 10:20 PM|
|12-08-2003 09:07 PM|
|12-08-2003 08:53 PM|
It takes a little longer to do its job, but it is bio-degradable and smells nice.
|12-08-2003 08:48 PM|
DOESN'T BELONG IN THE ENGINE SECTION
This is a legitimate post, and interesting, but it's in the wrong area of the board. We need to pay attention to where we post. If it's electrical, there is a place for that and a general area for other non-specific topics.
|12-08-2003 08:13 PM|
When I bought my parts washer I went to Lowe's and bought mineral spirits. It cost ten bucks for five gallons and I got by with ten gallons in a twenty gallon washer. That sure beat spending thirty dollars for five gallons of the recommended solvent.
I've been using it like that for three years and NO problems with flammability or evaporation. Granted, it's evaporated a little and it's about time to add another five gallons (only about a gallon evaporated, but the pump is starting to draw air). It also cleans really well and I can only smell it when the lid is open on the parts washer.
On a side note, if I had put a full twenty gallons of the recommended solvent in there, I would have had more money in solvent than I had in the washer itself.
|12-08-2003 06:40 PM|
|badknuckles||works fine as parts washer i dont know what you would do with your parts washer that it would catch on fire i genarally clean parts|
|12-08-2003 05:45 PM|
|crazy larry||mineral spirits was the recommended solvent for my cleaner. damn ebay crap. its what i use, we tested it for flammability, and were unsuccessful..... that was last august....|
|12-08-2003 04:11 PM|
Just wanted to ditto above. You are asking for a catastropy using either as washer fluid.
|12-08-2003 03:57 PM|
PLEASE! Do not use paint thinners or Mineral Spirits in your parts washers! MUCH to flammable! Use the washer recommended cleaning fluid ONLY!
I've used Varsol and a friend of mine is using one of the citrus based cleaners. I really see no difference in performance from one to the other. And will probably try one the next time I need cleaning solution.
|This thread has more than 15 replies. Click here to review the whole thread.|