Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> blowing smoke
User Name
Password
lost password?   |   register now

Thread: blowing smoke Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-24-2002 09:45 AM
cncmaster Well the carb is a stock remanufactured Q-jet 4-bbl Rodchester. The car is a 80 Trans Am. Witch came with a 305. I replaced the block with a 350 with all the origonial 305 equment. It runs rich. You can smell the fuel. I might of confused, condinsation for the white smoke. It only happens when I first warm it up in the morring. It seems to idel ok, not shakey or any thing. And the only trouble code I get is ( No reference pulses to the ECM ). What that all means I'm not sure. Help me out guys.


THX...
09-23-2002 08:32 PM
Ted655 Mine is just a chunk of steel, with a guage, a compression hose, a valve with a air hose fitting. You screw it in like a comp guage. hook an air line up. turn the valve on. charge the cylinder with air, turn the valve off and watch for leakdown. If there is any, you open the valve and run around listening for the hissss. If you use a regular compression hose, remove the check valve that is in some of them. Bubbles in the radiator are the coolest, followed by the air coming out of the dipstick. YES! It WAS a tired tired engine. But it feels better now!
09-23-2002 03:12 PM
72 chevy Someone told me a while back how to make a "home made" leakdown tester, cant remember. Any ideas or articles people?
09-23-2002 01:42 PM
Ted655 Jeff..If you suspect H-gasket problems, I'm going to reccomend buying (or borrowing) a cylinder leakage tester.$65.00, but worth it. It can tell you things about your valve-cylinder-heads that no compression guage can. Basicly (i hate it when my kid uses that word), you put compressed air into each cyl., then run around and look/listen for air leaks. Air coming from the tail pipe, valve covers, manifold, radiator, crankcase. <img src="graemlins/mwink.gif" border="0" alt="[mwink]" />
09-23-2002 01:31 PM
bullheimer as was stated white smoke is water, not the kind steaming when the condensation inside the exhaust heats up in the morning and blows out, but after it's all warmed up: blown gasket somewhere like a head gasket. that will cause your water to go down, power should go down=compression check, also can use a carbon analizer to check for it in your radiator water if you find a shop with one sometimes it can turn your water oily or grey. a pressure check on the radiator may indicate that too but maybe not, i have a leak in my heater core a pressure check can't detect. good luck
09-23-2002 09:31 AM
jeff germano Well my motor is a 79. I replaced the left heads gasket. because it was leaking oil where it met the intake manifold but i do believe the gasket was quite brittle. Iregret not doing the other side. Do you think thats what it is. Some times i have water come out of my tail pipes not much but a little. also after a few hundred miles my coolant is down about 2 inches or so. is that normal. i cant say i burn oil because the little smoke i have is just white also because my crankshaft seal leaks a little so the dipstick isnt accurate. I did not lose any noticable power. Please help thank you
09-23-2002 06:33 AM
Ted655 Some oil will run down the valve stems and colledt on the pistons. When you start up that little amount gets burned. As the valve guides wear it becoms more noticeable.
09-22-2002 09:05 PM
78 monte How many miles on the motor???Do it use oil??Do it use coolant??Do it make bubbles in radiator??Do it only do it when you first start it??Do it make you annoyed when I keep saying do it??Do it??
09-22-2002 07:56 PM
jeff germano I blow a little white smoke when i rev up the engine. Its a 350. But only when i give it gas why is that. its only noticable if you are behind strairng at the tailpipes.
What could it be
09-22-2002 06:57 PM
78 monte Ever burn copper in a camp fire???

[ September 22, 2002: Message edited by: 78 monte ]</p>
09-22-2002 05:48 PM
Ted655 That was...boiled gas, it should have had a green tint to it.
09-22-2002 01:03 PM
Croz Hey ted, i had a gas leak that happened to fall on my Headers and it boiled off as a white vapor that came pouring into the car, my nose and throat hurt for 2 weeks after that one....
09-22-2002 08:08 AM
dallam1 Hey Not Mr. Goodwrench; It ain't me man. It's my wifes old night gown that she wears with all of those worn out spots in just the right places. I wish she'd get rid of that thing!!
09-22-2002 07:40 AM
notmrgoodwrench hey man did you ever figure out what is causin all those kids....i did finally after 4 lol in my case it was the water i know it was so now i dont drink that crap aint had another one yet
09-21-2002 08:53 AM
dallam1 Hey 78 Monte, You stick with us, man. You'll see all sorts of colors. I even see red when my wife tells me there's another little one the way. We're up to five of the little screamers! I know, I should go out and check the color of my tail pipe emissions more!!
This thread has more than 15 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.