Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> General Rodding Tech> Welding exhaust piping
User Name
Password
lost password?   |   register now

Thread: Welding exhaust piping Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-02-2004 02:39 PM
tm454 Lincoin makes and excellent 120V welder. I got a welder with the gas option and cart used for $325. Watch the papers for a used one or get a new one and build your cart.


Tazz


Rat Rods Rule!
12-29-2003 08:06 PM
302 Z28 Do not buy a 120v MIG machine, you will soon wish you had purchased a 230v one instead.

Vince
12-23-2003 10:00 PM
willys36@aol.com I use oxy/acetylene on header construction. Give a lot more control and cleaner looking job. Also, remember to run a brazing fillet around the tube/flange joints. Improves strength, quietness and extends the life of the header.
12-23-2003 06:15 PM
84Z nongas, .6-.8mm wire width

or non gas 115 volt, 90 amp max, 0.035'' or 0.030'' wire capacity, flux core wire
12-23-2003 05:52 PM
BOBCRMAN@aol.com Depends on welder size(capacity) and wire size, gas or no gas.
12-23-2003 05:32 PM
84Z
Welding exhaust piping

What's an adequate amp/volt needed for a mig welder to weld exhaust piping easily. Specifically aluminized 16 gauge and a higher gauge.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.