Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> TRW 327 Pistons
User Name
Password
lost password?   |   register now

Thread: TRW 327 Pistons Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-14-2002 06:14 AM
Biggarmike L2165 are flat top? I built a 327 last year with L2166, they were .100" dome. Too much for pump gas with 64cc heads. Yours should be close, but ok.

[ October 14, 2002: Message edited by: Biggarmike ]</p>
10-13-2002 08:12 PM
agearhead 8.96 with 4" bore 9.03 with +.020 9.07 with +.030 9.11 with +.040 9.18 with +.060
10-13-2002 06:18 PM
72trucker I have a 327 bored .060 over with flat-top trw cast pistons and 64cc heads. Lots of static compresion. Ratio is about 9.6-10:1 and I did the math (the 9.6-10 range is for any minor miscalculation). SO, the compression is up there for pump fuel, which is what I use. I had a hard time with detonation/pre-ignition. I had to richen the a/f ratio and go with colder spark plugs. Good Luck....
10-12-2002 05:02 PM
johnsongrass1 The only sure way to know is take measurements and do the mth
10-11-2002 07:51 PM
bullheimer could be. i know that flat tops are 9.2+ to 1 ona 350 with 76cc heads.76cc <img src="graemlins/crash.gif" border="0" alt="[crash]" />
10-11-2002 07:41 PM
MI2600
TRW 327 Pistons

I've got a set of forged TRW pistons for a 327 SBC. The TRW # is L2165. When I bought them I was told they were 9:1 with 64cc heads. I was going through a reference book (always accurate right!) and they were listed as 10:1. Anybody know a site with with specs...or even have personal knowledge about these?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.