Hot Rod Forum banner

seat swap for 1955 chevy pickup

9K views 6 replies 4 participants last post by  Thom Laybourne 
#1 ·
i was just wondering if there were any bench seats with a fold down console that would fit in my truck that have the same bolt pattern. i have a 55 chevy 2nd series pickup.
 
#2 ·
Not sure about the second series but for the 47-55 first a late 70's or early 80's Olds Tornado split bench will fit and has the fold down console. I don't think the bolt pattern is the same and you'll probably have to fab up a mount but it should fit even better in the second series trucks since they are a tad wider.

Centerline
 
#7 ·
12 Volt Lead

Just a 12 Volt lead wire. Use the frame for ground. I have the same truck and I am looking for a new seat also. If you can, please post a photo of what ever you end up with. I have just finished doing the power brake under the floor and am starting to move the gas tank to the rear frame. I hope to make a small electronics drawer to fit under the seat for the sound system. Keep me posted.

hr41pearl :cool:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top