Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Spacer between carb and intake manifold?...
User Name
Password
lost password?   |   register now

Thread: Spacer between carb and intake manifold?... Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-06-2004 08:40 PM
doc_rage That's true Bullheimer. I think I might as well go ahead and give it a try. I know it won't make any difference (maybe a tenth in gas mileage and no improvement in throttle repsonse), but it couldn't make this damn 2.8 run any worse Thanks for the reply.
02-06-2004 01:27 PM
bullheimer i've heard both good and bad but the bottom line is you cant tell till you try it. esp with the help of a dyno. most of the ones i've seen people use have the ones with four holes in them. good for top end usually. if you can get one free i'd at least try it. but i wouldnt buy one unless you knew for sure with your engine and how you drive it will help
02-05-2004 06:57 PM
doc_rage
Spacer between carb and intake manifold?...

Hey guys, how goes it. I have a 1985 Chevrolet S10 with a carbureted 2.8 V6. It already has an insulator gasket that goes between the carb and the intake manifold with a heated grid attached to it (probably an 1/8-1/4" thick or something) stock. I have heard of people using spacers between their TBI and intake manifolds, but also with carburetors to get a better fuel mixture. I was wondering if anyone thinks it would make a difference (good or bad) if I place a spacer on top of the EFE Insulator gasket to raise the carb even higher from the intake manifold. The spacer would basically be a insulator gasket w/o the heated grid since I have one just sitting here. I have a body lift, so hood clearance isn't an issue.

Just something I was thinking about. If anyone has any insight, it's appreciated.
__________________
1985 2.8L 4WD 5-spd Extended Cab: 48Kvolt Accel Coil, Accel 8mm spark plug wires, Taurus Electric Fan Conversion, 2.5" straight pipe from y-pipe into Flowmaster 40 series, 3" Body lift, Black spray paint paint-job....Still can't outrun a schoolbus

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:25 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.