Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 12 Bolt axle tubes ?
User Name
Password
lost password?   |   register now

Thread: 12 Bolt axle tubes ? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-14-2004 04:22 PM
Full Throttle The one I used was the same outside diameter as mine. I had to cut it to find out the thickness which was about a 1/4". I was assuming you have all the alignment tools and were going to reuse your ends. When I did mine I stubbed the tube off about 1" from the housing. I beveled both tube ends to be welded and used the alignment bar setup to get the tube centered. I then tacked the tube diameter in 8 places. After that fill in between the tacks using a cross pattern. You will have to do the same thing to the housing end. If you are looking for a complete weld on tube with perches and end I dont know about that. My setup was for ladder bars and I was building the brackets myself.
03-14-2004 10:12 AM
JayT Full T,
Thanks for the reply. Will the ends be the same and is the tube same strength? I better get with it.. The owner of the 12bolt has about 20 trailer axles laying around. I'll tell him to check them.


Jay
03-14-2004 07:14 AM
Full Throttle I tore a axle tube on my drag car once before and replaced it with a trailer axle tube the same size. I didnt see the tubes on Moser web site. You might look up a local trailer buisness and buy a junk axle tube from them.
03-13-2004 09:44 PM
JayT
12 Bolt axle tubes ?

I'm trying to find axle tubes for a 12bolt chevy rear end. Is there any place on the net where I can get tubes? I have tried but i guess i'm hitting the wrong keys.

Thanks in advance..

Jay

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.