Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> C5 output shaft loose
User Name
Password
lost password?   |   register now

Thread: C5 output shaft loose Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-17-2004 04:50 PM
Jmark Well, I've never had a Ford tranny apart, just my chevy TH350, but based on my limited experience with mine, i'd say the rear bushing in the case is shot and probably a few others may be too.

Mark
03-17-2004 10:00 AM
k2mooch
C5 output shaft loose

After taking the C5 to a shop for a bench rebuild, they put a shift kit in and handed it back to me. I locked the converter into its splines, bolted it to the block, then converter bolts. Hooked everything else up snug and added 8 quarts very slowly (I heard adding it too quick causes an air pocket). After starting the car, I moved it through all the gears and then added about 3 more quarts till it read full, then shut it off to set a while.

When I started it back up and put it in drive to test, it engaged fine and I gave it a little gas. It felt like it was slipping going up the driveway, so after about 12 feet, I dropped it back to neutral and rolled it back down. I then put it back in drive to have no engagement at all. . . in any gear.

After removing the tranny, I noticed that the seals were still there in the front and rear, but the output shaft was loose. It had enough play in it that the splines would contact the housing.

Did I do something wrong on the install that would cause this, or was it assembled wrong? The guy is trying to figure out who's fault it was and that's what I told him happened pretty much word for word. Anybody have a similar problem with a rebuild?



MoocH

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.