Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> T-5 Dust shield question
User Name
Password
lost password?   |   register now

Thread: T-5 Dust shield question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-03-2004 12:49 PM
72chevy240z Thanks, I orders the half dust shield for my t-5 part #10241153 from gmpartsdirect.com for 11 bucks shipped.
06-03-2004 12:21 PM
slavboy1 I agree i'd just put the smaller lower shield on and call it done. But ya gotta put that lower one on or you might have some interesting concequences.
06-02-2004 10:03 PM
DoubleVision far as I can tell, you`ll only have to remove the starter to install the dustshield, then it just bolts on to the tranny`s lower bell housing, replace the starter and it`s done. the tranny wouldn`t need a upper dust shield, the block is the dust shield, any open area is subject to dust and other debris as well, so no, a upper piece would not be needed since the bell housing sits flush on the block.
06-02-2004 11:22 AM
72chevy240z
T-5 Dust shield question

Finally have my 68 327/1989 wc T-5 installed where I want it in my 73 240z after putting it in and taking it out 5 times.

I may have made another mistake forcing me to pull the motor/tranny again... I did not put on the dust shield between the tranny and motor behind the flywheel.

I am attaching a pic of the reason why i did this. I think the t-5 has only a lower dust shield not a whole one the goes behind the entire block. Am i wrong? maybe its a two piece? I have searched and cant figure this out. In the pic the upper shield is for a 86-92.

If I am right and it only requires the lower shield for a t-5 would a dusty land shield from a post 85 camaro work with my 89 t-5 and my 68 327 block?

Hopefully it only requires the lower shield and can be put on with the motor tranny in the car?
thanks again..bob

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.