Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Well I did not think it could get worse!!
User Name
Password
lost password?   |   register now

Thread: Well I did not think it could get worse!! Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-04-2004 10:47 AM
tresi Never seen anyone set the floats with a feeler gage. Try holding the float bowl upside. Adjust the float so that the top of the float is level with the cast in boss around the screw holes. The float should now be parallel with the flat area on the inside of the float bowl. This would be the top when you turn it right side up. If that doesn't get your float close enough to run some is wrong with your needle and seat.
07-04-2004 08:54 AM
cub What should the gap on the back of the float ( the metal piece that contacts the seat) set at. I should be able to set that with a feeler gage,right? I have the holley rebuild book and it says to set it with a pencil under the float. I had no luck at that so now I would like to set it with feeler gage if anyone knows the setting. Thanks


Holley 4779-3
07-03-2004 10:06 PM
troy-curt Needle and seat, bad, missed, out of adjustment.
Or float in a bind.

Remove the bowl and look at it, it should be obvious.

Troy
__________________
If you don't make mistakes. your not doing anything.

69 ss rs full custom camaro 98 ISCA grandchampion
69 ss rs bb camaro wifes driver
66 Elcamino 350/all dz parts,ac,windows,loaded,my driver
69 ss chevelle bb conv.fresh frame off
26 T sedan street rod
07-03-2004 10:00 PM
cub
Well I did not think it could get worse!!

It did! I rebuilt my holley 750.There are 2 5/16" tubes that come out the top of the carb. I have gas squirting out of the top of the back tube, Any ideas what I did wrong ? Thanks for any help.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:54 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.