Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> won't start after running
User Name
lost password?   |   register now

Thread: won't start after running Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-28-2013 02:56 PM
UPandComing what does this have for an ignition system?
01-27-2013 01:49 PM
camaro355 sounds like you need to replace the ecm had a mustang 5.0 that did the same thing and turned out it was the pcm
09-12-2004 06:37 AM
where do i hold it so i don't get shocked?
call a friend over to help you work on it, give him a few beers and your set. Sometimes you can get a couple of tests out of him if you tell him he held it in the wrong place
09-12-2004 01:22 AM
HARVICKx29 i've got some noid lights.. i'm gonna check that out tomorrow. the spark plug thing i'll try tomorrow as well. the reason for the replacement of all those parts is- starter+starter solenoid- burned up. the switch on the column was bad. the wires were replaced after finding 2 were broken. plugs were fouled up. cap and rotor just because everything else was being replaced. ign module because we had no spark originally. fuel filter because the one on the truck was nasty looking and it wouldn't hurt since i had one.... sorry i just wanted to explain myself so i didn't seem like one that just throws parts on hoping it'll fix it. :-)

but hey, i held a spark plug the other day to see if it had spark. shocked the bigeezuz out of me. i had those mechanix gloves on and was holding it at the boot. where do i hold it so i don't get shocked?
09-12-2004 12:33 AM
willowbilly3 Use a spark tester like a spark plug with the electrode cut off. You want to see a good blue or whitish blue spark that can jump at least 1/4 inch.
Go buy a noid light for a couple buck and plug it into one of the injector wire connectors. It should flash once every engine revolution. Now if you have that and 40 psi it should run.
It sounds like maybe a heat soak problem. Don't overlook the after market ignition module, NOBODY makes one as good as Ford does. I would rather have a junkyard Motorcraft module than a new one from NAPA or anyone else.
It sounds like you have some basic diagnostic skills but get frustrated and go to throwing parts at it.
Also if you have the TFI type of module (on side of dist.) don't forget the dielectric grease. It helps conduct away the heat from the module. It will not live long without this.
09-11-2004 10:25 PM
won't start after running

87 ford bronco-302-efi. we had a problem of it not starting one day. it just cranked. we went to test it and the switch on the column got stuck and the engine kept cranking after we pulled the key out.... we put in a new starter, starter solenoid, ignition starter switch. tested it- no spark. new ignition module. started. so we then did a tune up-cap, rotor, plugs, wires. now when the truck is driven anywhere and shut off it will not start. needs to sit for a few hours. we installed a new fuel filter and coil-didn't help. fuel pressure is at 40 psi while cranking. book says 35 to 40. i installed an inline spark tester- the light lights up but not bright at all- not sure how bright it's supposed to be. any ideas out there? it's in my driveway and theres nothing worse then a ford in a chevy guys driveway.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 08:29 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.