|01-06-2005 03:48 PM|
|banksbrian||You know, that is a good idea. I will take photos and post them|
|01-06-2005 03:42 PM|
If you are using the front engine mounts and a rear crossmember only, that is a long stretch. Causes the engine/trans to flex too much.
Is this rebar supporting anything?
My opinion....I think that you should be looking into side mounts for the engine, and a new crossmember for the tranny. Sounds like someone has butched this pretty well.
Either that or find some proper mounts for the bell housing.
Any pictures of this "mess"?
|01-06-2005 03:33 PM|
Stock mounts up front on the engine. Can you believe someone actually welded rebar between the frame and the scattershield? Crazy.
Thanks for your reply.
|01-06-2005 01:29 PM|
What are you using for engine mounts....stock, side mounts?
I ran my 55 for years with the stock front/bellhousing mounts. A trans crossmember was not necassary.
The drop on your crossmember will depend on the angle that the motor is sitting at...Personally, I don't think that any drop is needed.
|01-06-2005 12:50 PM|
Muncie transmission mount for my 55 2 door
I have a 55 Chevy that has a 1972 Chevy 350 bolted to a Muncie 4 speed. There is a jerry rigged transmission crossmember, it is horrible. I need a part source for an aftermarket transmission crossmember for this setup. Any idea what the number of inches of drop are required, if any.